ViewSonic NMP-570W Betriebsanweisung PDF herunterladen (Seite 8)

2. Conguring the NMP-570/NMP-570w Media Player

2.1. System connections

1. Attach a video cable (either VGA or HDMI) to your monitor.

When using the VGA connection, your monitor should support XGA

(1024x768) resolution or greater. For audio output, you will also need

to connect a stereo RCA cable from the NMP-570/NMP-570w to your

monitor.

When using an HDMI connection, audio is sent along with video over the

HDMI cable, so no additional cables are required.

Reminder: If you do not see anything on screen, check your monitor

video input mode.

2. Attach the AC power adapter to power on the unit. Shortly afterwards, the

following progress bar will be displayed on your monitor:

3. Player boot process takes approximately 90 seconds to complete. The

player will indicate that it is ready for content sync via the USB port or, if

content has been loaded, begin playback immediately.

After performing the initial setup as

outlined above, the player will boot

into the “Open Standard Media Player”

screen. Plug in a USB keyboard to

enter conguration menus.

If you have already loaded media

contents into the player, contents will

90 seconds

Troubleshooting TipsTroubleshooting Tips

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Keine Kommentare

ViewSonic NMP-570W Betriebsanweisung Seite 8