ViewSonic CD5230 Betriebsanweisung PDF herunterladen (Seite 16)

ViewSonic CD5230 14

How to Mount and Attach Options to the

LCD Monitor

Lay the protective sheet on a table, which was wrapped around the monitor when it was packaged,

beneath the screen surface so as not to scratch the screen face.

This device cannot be used or installed without the Tabletop Stand or other mounting accessory. Failure

to follow correct mounting procedures could result in damage to the equipment or injury to the user or

installer. Product warranty does not cover damage caused by improper installation.

Failure to follow these recommendations could result in voiding your warranty.

Use M6 mounting screws (having a length 10-15mm longer than the thickness of the mounting bracket)

and tighten them securely. (Recommended torque: 470-635N•cm). The mounting interface should

comply with the UL1678 standard in North America. ViewSonic also recommends the use of mounting

interface that complies with the TÜV-GS standard.

Caution:

For preventing the monitor from falling.

• Install the monitor with metal brackets for wall or ceiling installation (commercially available) on your

own responsibility. For detailed procedures of installation, refer to the instructions of the metal

brackets.

• To lessen the probability of injury and damage resulting from fall of the monitor in case of earthquake

or other disaster, be sure to consult the bracket manufacturer for installation location.

• To lessen the risk of falling of the monitor, thread commercially available rope (having a load capacity

at least 1960N (200kgf) through the handles at the right and left of the monitor and secure the rope to

the wall mount brackets or ceiling mount brackets.

• Do not sleep where the monitor may topple over or fall in case of an earthquake or other disaster.

400mm

200mm

LCD monitor

10-15mm

Thickness of the

mounting bracket

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 52 53

Keine Kommentare

ViewSonic CD5230 Betriebsanweisung Seite 16