ViewSonic PJ255D Betriebsanweisung PDF herunterladen (Seite 29)

Changing the lamp

The projector will detect the lamp life itself. It will show you a

warning message The Lamp has been in use for over 1400

hours. You should purchase a spare bulb. When you see this

message, please contact your local reseller or service center to

change the lamp as soon as possible or refer to the following

instructions to replace it yourself.

Make sure the projector has been cooled down for at least 30

minutes before changing the lamp.

Warning: Lamp

compartment is hot!

Allow it to cool down

before changing lamp!

Lamp Changing Procedure:

1. Turn off the power to the projector by pressing the Power

button.

2. Allow the projector to cool down at least 30 minutes.

3. Disconnect the power cord.

4. Use a screwdriver to remove 2 screws from the cover.

5. Remove the cover.

6. Remove the 2 screws from the lamp module.

7. Pull out the lamp module.

To replace the lamp module, reverse the previous steps.

Warning: To reduce

the risk of personal

injury, do not drop the

lamp module or touch

the lamp bulb. The bulb

may shatter and cause

injury if it is dropped.

ViewSonic PJ255D

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Keine Kommentare

ViewSonic PJ255D Betriebsanweisung Seite 29